MOTU 8pre User's Guide Page 62

  • Download
  • Add to my manuals
  • Print
  • Page
    / 68
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 61
MOTU SMPTE SETUP
62
SETTING UP FOR SMPTE TIME CODE SYNC
In summary, the 8pre system can resolve directly to
SMPTE time code. It can also generate time code
and a time base, under its own clock or while
slaving to time code. Therefore, the 8pre can act
both as an audio interface and digital audio
synchronizer. You can use the 8pre to slave your
audio software to SMPTE as well, as long as your
software supports sample-accurate sync, which is
the means by which the software follows the 8pre.
The accuracy may not be sample-accurate, but in
most cases it will be very close.
Macintosh computer running
AudioDesk, Digital Performer or other
sample-accurate software.
Figure 12-3: Connections for synchronizing the 8pre directly to SMPTE time code.
Choose SMPTE as the clock source in AudioDesk, Digital
Performer, or the MOTU Audio Setup. This setting can also be
made in the MOTU SMPTE Setup (shown below).
8pre interface
SMPTE time code source
audio cable bearing LTC
(Longitudinal Time Code)
Any analog input
FireWire cable
Launch the MOTU SMPTE Setup software to specify the time code input, frame rate and
amount of freewheel. Also, confirm that the Clock Source/Address is SMPTE/SMPTE.
When lockup is achieved, the CLOCK light illumi-
nates and the TACH light blinks once per second.
In AudioDesk or Digital Performer:
1. Choose Receive Sync the Setup menu.
2. Choose the Sample-accurate option
shown to the left.
3. Make sure that Slave to External Sync is
checked in the Studio menu.
Use this setup if you have:
A SMPTE time code source, such as a multitrack tape deck.
Host software that supports sample-accurate sync.
This setup provides:
No sample-accurate locating.
Continuous sync to SMPTE time code.
Sub-frame timing accuracy.
Transport control from the SMPTE time code source.
!8pre Manual/Mac Page 62 Tuesday, October 12, 2010 5:52 PM
Page view 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 68

Comments to this Manuals

No comments