MOTU Audio Express User's Guide Page 77

  • Download
  • Add to my manuals
  • Print
  • Page
    / 82
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 76
MOTU SMPTE CONSOLE
77
COMPANY
CONFIDENTIAL
MOTU
The 4pre cannot freewheel address without clock.
Therefore, the Freewheel Address setting will always
be lower than or equal to the Freewheel Clock
setting, and both menus will update as needed,
depending on what you choose.
The ‘Infinite freewheel setting
The Infinite freewheel setting in the Freewheel
Clock menu causes the 4pre to freewheel
indefinitely, until it receives readable time code
again. To make it stop, click the Stop Freewheeling
button.
Stop Freewheeling
The Stop Freewheeling button stops the system if it
is currently freewheeling.
GENERATOR SECTION
The Generator section (on the right-hand side of
the window in Figure 10-1) provides settings for
generating SMPTE time code.
Level
Turn the level knob to adjust the volume of the
SMPTE time code being generated by the 4pre. The
level knob disappears when the Destination is set
to None.
Tach light
The Tach light blinks once per second when the
4pre is generating SMPTE time code.
Destination
In the Destination menu, choose either SMPTE (to
generate time code) or None (to turn it off).
Stripe
Click this button to start or stop time code. To set
the start time, click directly on the SMPTE time
code display in the Generator section and type in
the desired start time. Or drag vertically on the
numbers.
Figure 10-2: Setting the time code start time.
Regenerate
This option, when enabled, causes the generator to
generate time code whenever the 4pre is receiving
SMPTE time code.
RESOLVING CUBASE OR NUENDO TO TIME
CODE
To resolve your 4pre and Cubase or Nuendo
directly to SMPTE time code with no additional
synchronization devices, use the setup shown in
Syncing to SMPTE time code on page 78. Make
sure the Master Clock Source setting in the MOTU
Audio Console window is set to SMPTE. Also,
make sure that you’ve connected an LTC input
signal to a 4pre analog input, and that you’ve
specified that input in the SMPTE Source menu in
SMPTE Console.
Click here to edit
the start time, or
drag vertically on
the numbers.
Page view 76
1 2 ... 72 73 74 75 76 77 78 79 80 81 82

Comments to this Manuals

No comments