MOTU 8pre User's Guide download pdf (Page 62)

CUEMIX FX

Choosing a channel to display

The X-Y Plot follows the currently chosen Scope

channels (Figure 9-1 on page 48).

View controls

The View controls (Figure 9-18) provide several

options for the X-Y Plot display.

Figure 9-18: View controls

Pausing the display

The Pause button in the upper right corner of the

View section (Figure 9-18) allows you to freeze the

display at any time. To resume, click the button

again. The level meters will remain active while the

display is paused.

Line/Scatter

Choose either Line or Scatter from the menu in the

View section (Figure 9-18) to plot each point

(sample) as either a single pixel or as a continuous

line that connects each plot point to the next, as

shown below in Figure 9-19.

Figure 9-19: The same X-Y Plot displayed in Line versus Scatter mode.

☛ Line mode is signiﬁcantly more CPU intensive

than Scatter. You can reduce Line mode CPU

overhead on the X-Y Plot by reducing the Length

parameter (described below).

Color/Grayscale

In Color mode (Figure 9-18) the most recently

displayed audio data is shown in red, which fades

to yellow, green and then ﬁnally blue, before

disappearing. In Grayscale mode, data is ﬁrst

shown in white and then fades to gray. To adjust the

scale of this color/brightness change, see “Decay”

on page 63.

Axes

The Axes control (Figure 9-18) sets the opacity of

the grid displayed in the graph, from 100% (fully

visible) down to 0% (fully hidden).

Horizontal and vertical controls

The Horizontal and Ve r t i c al controls (Figure 9-20)

conﬁgure the value range of the x-axis (left channel

amplitude), and y-axis (right channel amplitude),

respectively. Click and drag the values up or down

to set them, or double-click to return to the default

value.

There are two modes for the controls: Zoom/Offset

and Min/Max. To change the mode, use the menu

shown in Figure 9-20.

Figure 9-20: Setting the Horizontal or Vertical control modes.

In Zoom/Offset mode, Zoom scales the axis. Pos

moves the lines marking x = 0 left and right, or y =

0 up and down.

In Min/Max mode, Min and Max let you scale the

grid by moving the -1.0 and +1.0 points along the

axis. Min/Max mode lets you control the graph

boundaries directly.

Pause button

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 79 80

Comments to this Manuals

No comments

MOTU 8pre User's Guide Page 62

Comments to this Manuals

Related products and manuals for Recording Equipment MOTU 8pre