REDUCING MONITORING LATENCY
58
Follow the directions below in the section that
applies to you.
Controlling CueMix DSP from within AudioDesk
or Digital Performer
To t u r n on CueMix DSP in AudioDesk and Digital
Performer:
1 From the Setup menu, choose Configure Audio
System>Input Monitoring Mode.
2 Choose the Direct hardware playthrough option,
as shown below in Figure 10-7.
3 From the Studio menu, choose Audio Monitor,
and enable Audio Patch Thru (the button with the
headphone icon on it).
Figure 10-7: Enabling CueMix DSP in AudioDesk or Digital Performer.
Once enabled, CueMix DSP monitoring is tied
with Digital Performer or AudioDesk’s Audio Patch
Thru feature: when you record-enable a track, the
track’s input is routed directly to its output (via
CueMix DSP in the UltraLite hardware). For
example, if you record-enable a track called guitar
in your DP or AudioDesk project, and its audio
input assignment is Analog in 2, and its audio
output assignment is channels 7-8, CueMix DSP
no-latency hardware monitoring will automatically
be set up from analog in 2 to outputs 7-8.
Controlling CueMix DSP from within other
software
Consult the manual for your software.
!UltraLite Manual/Mac Page 58 Monday, September 12, 2005 6:52 PM
Comments to this Manuals