MOTU Digital Timepiece User's Guide Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 101
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
INSTALLATION
17
Connecting ADATs as slaves
In most circumstances, you will want the Digital
Timepiece to be the sync master over your
ADAT(s). If so, connect the Digital Timepieces
ADAT Sync Out port to the Sync In of your first
ADAT using the sync cable supplied with the
ADAT as shown in Figure 3-7. Dont worry about
setting the ADAT device ID: the Digital Timepiece
sets it automatically.
Figure 3-7: Connecting an ADAT as a slave to the Digital Timepiece.
If you have several ADATs, you can chain the rest of
them to the first one as shown in Figure 3-8.
Figure 3-8: Connecting multiple ADATs.
Connecting the Digital Timepiece as a slave
If you have an Alesis BRC, and you want to use it as
your master control surface, you will need to
connect the Digital Timepiece as the last device in
your ADAT chain, as shown below in Figure 3-9,
with the BRC as the master of the chain.
Figure 3-9: Connecting a slaved Digital Timepiece as the last device in
an ADAT chain.
ADAT sync cable
Digital Timepiece
ADAT
Sync In
port
ADAT
Sync
Out
ADATs
Digital Timepiece
Sync In
ADAT
sync cables
Sync Out
Sync In
Sync Out
Sync In
Sync Out
etc.
ADAT
Sync Out port
Digital Timepiece
BRC
ADAT
Sync In
Sync Out
ADATs
Sync In
ADAT
sync cables
Sync Out
Sync In
Sync Out
Sync In
Sync Out
etc.
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 100 101

Comments to this Manuals

No comments