MOTU 896 User's Guide download pdf (Page 102)

CUEMIX FX

102

View controls

Figure 9-33: View controls

You can show and hide the FFT display,

spectrogram or EQ band response curves as

desired using the Display Options menu options

(Figure 9-29). These settings are independent of

the small graph display options (Figure 9-10), so

you have the ﬂexibility to display different

combinations in each graph.

☛ “Show EQ Controls” will be available only if

the focused pair are a stereo input pair or stereo

output pair.

Logarithmic or Linear X-Axis Scale

The x-axis defaults to a logarithmic scale, but can

be changed to a linear scale if desired. In the View

controls (Figure 9-33), click Logarithmic to access

the x-axis scale options menu. With a linear scale

selected, frequency is constant, but the width of

each octave along the x-axis is different. With a

logarithmic scale selected, octaves are displayed

with a constant width, but frequency is displayed

logarithmically within each octave.

Axes display

The Axes control (Figure 9-33) sets the opacity of

the grid displayed in the graph, from 100% (fully

visible) down to 0% (fully hidden).

Pausing the display

The Pause button in the upper right corner of the

View section (Figure 9-33) allows you to freeze the

display at any time. To resume, click the button

again.

The info box

When any EQ ﬁlter point is selected or dragged in

the full window graph, the info box is shown next

to the point in the full graph display (Figure 9-34).

Figure 9-34: The Info Box.

The info box includes the industry standard

scientiﬁc note (pitch) name when the control point

is located at a frequency that resides within a

prescribed note range, where C4 is middle C. The

note number is accompanied by the number of

cents (±50) above or below the exact frequency for

the note. If the control point is dragged outside the

note range, only the frequency is shown.

Horizontal controls (frequency axis)

The Horizontal controls (Figure 9-35) conﬁgure

the value range of the x-axis (frequency). Click and

drag the values up or down to set them, or double-

click to return to the default value.

There are two modes for the controls: Zoom/Offset

and Min/Max. To change the mode, use the

Horizontal control menu (Figure 9-35).

Figure 9-35: Horizontal control menu

In Zoom/Offset mode, Zoom sets the display zoom

from 1x to 100x, where the number represents the

zoom factor relative to the entire frequency range.

For example, when the horizontal zoom value is 1x,

the entire frequency range from 10 to 24000 Hertz

is displayed; when the horizontal zoom value is 2x,

Pause button

Display options

896mk3 Hybrid book Page 102 Friday, August 19, 2011 1:44 PM

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 133 134

Comments to this Manuals

No comments

MOTU 896 User's Guide Page 102

Comments to this Manuals

Related products and manuals for Recording Equipment MOTU 896