MOTU 896 User's Guide download pdf (Page 95)

CUEMIX FX

displaying an input meter). Click Pre to view levels

before any input channel processing besides trim;

click Post to view levels after all channel processing

(EQ, compression, M/S decoding, L/R swap, etc.)

The Reverb tab

The Reverb tab (Figure 9-23) provides access to the

896mk3’s single, global reverb processor, which

provides high-ﬁdelity reverberation and graphic

control over its parameters.

Figure 9-23: The Reverb tab.

Enabling reverb

Use the enable/disable button (Figure 9-23) to turn

the reverb processor on or off. Since reverb uses

considerable DSP resources, it is best to leave it off

when you are not using it.

Routing inputs, busses and outputs to the

reverb processor

The reverb processor is a single, independent unit

that provides stereo reverb.You can route multiple

signals to it from various points (sends) in the

CueMix FX mixer, but all incoming signals to the

reverb processor are merged and processed

together. The resulting stereo output from the

reverb can then be inserted into a mix bus or

output using stereo returns.

Reverb sends

The following signals can be sent to the reverb

processor via their corresponding sends (discussed

earlier in this chapter):

■ Mono or stereo inputs (Figure 9-3 on page 79)

■ Mix bus output (Figure 9-2 on page 77)

■ Outputs (Figure 9-6 on page 82)

Reverb returns

The stereo output from the reverb processor can be

sent to the following destinations via their

corresponding returns (discussed earlier in this

chapter):

■ Mix bus outputs

■ Outputs

■ The computer (via the Reverb Return bus)

Split point

The Split Point (Figure 9-23) prevents feedback

loops that would be caused by a signal being sent to

the reverb processor and then returned to the same

signal path.

Mix

When the Split Point is set to Mix, the returns in the

Mix bus tab become active and the sends in the

Output tab gray out. This allows you to send from

inputs and mixes and return to mixes and outputs.

Reverb

enable/disable

Mid band reverb

time handle

Crossover

handle

Low band

(yellow)

High band

(purple)

896mk3 Hybrid book Page 95 Friday, August 19, 2011 1:44 PM

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 133 134

Comments to this Manuals

No comments

MOTU 896 User's Guide Page 95

Comments to this Manuals

Related products and manuals for Recording Equipment MOTU 896